Danfoss ESMD Temperature Sensor User Manual
ESMD
- Drill a 6.5 mm hole in the middle of the air duct at a place where the temperature sensor is not influenced by stratified air, heat or humidifiers. Place the temperature sensor in the air duct (A).
- Drill two 4 mm holes though the flange holes (B) of the ESMD.
It is recommended to mount the ESMD with the cable inlet facing down.
Use two 5 mm self-cutting screws (not delivered) for mounting the ESMD. - Make a small hole in the black rubber cable inlet and put the cable through the inlet (C).
Press the orange tabs to connect wires. Polarity not important. - Mount white front cover onto the ESMD.
Dimensions
👉 ESMD: www.danfoss.com
👉  https://www.youtube.com/user/DanfossHeating
-> Playlists -> How-to Videos -> District Energy installation videos
Danfoss A/S
Climate Solutions • danfoss.com • +45 7488 2222
Any information, including, but not limited to information on selection of product, its application or use, product design, weight, dimensions, capacity or any other technical data in product manuals, catalogues descriptions, advertisements, etc. and whether made available in writing, orally, electronically, on line or via download, shall be considered informative, and is only binding if and to the extent, explicit reference is made in a quotation or order confirmation. Danfoss cannot accept any responsibility for possible errors in catalogues, brochures, videos and other material.
Danfoss reserves the right to alter its products without notice. This also applies to products ordered but not delivered provided that such alterations can be made without changes to form, fit or function of the product.
All trademarks in this material are property of Danfoss A/5 or Danfoss group companies. Danfoss and the Danfoss logo are trademarks of Danfoss A/5. All rights reserved.
Download PDF
Danfoss ESMD Temperature Sensor User Manual PDF Download
