KNZ EZPZ 5.1 Bluetooth Over Ear Air Conduction
Headphones User Manual
PRODUCT IMAGE
- Mic+ Indicator Light
- Multifunctional Button
- Type-C Charging Port
- Memory Wire
- Decoration Housing
- Sound Hole
- Silicone Pand
PARAMETERS
Bluetooth Version: 5.1
Transmission Distance: 33ft
Frequency Response: 20HZ-20KHz
Output Sensitivity: -85dB
Microphone Sensitivity: -42dB
Battery Capacity: 140mAh
Speaker Impedance: 32Q
Speaker Rated Power: 2mw
Speaker Drive Unit: tp14.32Q
Play Times: Approx. 8hrs (Medium Volume)
Charge Time: Approx. 1.5h
Supports: HSP. HFP. A2DP
Net Weight: Approx. 25g
ACCESSORIES
- Type-C Charging Cable x 1
- User Manual x 1
FUNCTIONS
Switch On/Off
- Switch On: Long press the multifunctional button for 3 sec.
- Switch Off: Long press the multifunctional button for 6 sec.
- Auto Shutdown: It will switch off automatically if you do not connect it to your cell phone within 3 minutes after switching it on.
Pairing
- Long press the multifunctional button for 3 sec to power it on and enter into pairing mode.
- Turn on Bluetooth on your phone, search far “EZPZ” and click it for pairing. There will be a voice prompt if the pairing is made successfully.
Music
When playing the music, you may operate through the headset.
To pause/play the music, click the multifunctional button to control. Far next song, double click the multifunctional button.
Activate Voice Assistant (Mobile Phone Supports)
When the music is playing or has been paused, long press the
multifunctional button for 3 sec to activate SIRI {“du” sound will follow). One more click ta stop.
Phone Call
About phone call, you may operate through the headset.
- To Answer the Call: Click the multifunctional button, and a voice prompt will follow.
- To Reject the Call: Long press the multifunctional button for 2sec, and a voice prompt will follow.
- To Hang Up: Click the multifunctional button during a call, and a voice prompt will follow.
- Pick Up Another incoming Call: Double click the multifunctional button to pick up t he call while placing the current call on hold.
Double dick again to place the current call on hold, and resume the previous one. One dick to hang up the current call, and resume the previous one. - Switch Modes between Cell Phone and Headset During a Call: Long press the multifunctional button for 2 sec.
Charging
The light will flicker in red during charging. When it is fully charged, the light will t urn off.
Troubleshooting
- Wireless headset fails to connect to the phone.
- Solution: Check if the headset is in Paring Mode or Re-Connection Mode and whether t he phone has EZPZ function on and is searching for paring device. Or check the list of EZPZ device an your digital device and remove headset from the list, and follow the user manual ta reconnect the headset with your device.
- Cannot turn on the headset.
- Solution: Check the battery to see if it is low.
- Can the battery of the wireless headset be replaced?
- Answer: No. Lithium-ion polymer in the headset is not detachable.
- Can the headset be used during driving?
- Solution: EZPZ is wireless so that it is very sensitive ta abject between the headset and the connected device. Check if there are any metal or other objects that may affect connection within t he effective distance.
- Unable to connect the headset with the phone within 33ft. Solution: EZPZ is wireless so that it is very sensitive to a objects between the headset and the connected device. Check if t here are any metal or other objects that may affect connection within the effective distance.
- Cannot hear audio playing when the headset is connected to the computer or phone.
- Solution: Check whether t he computer’s audio out put is already connected to wireless device and whether t he Bluetooth in the computer supports A2DP protocol. Make sure the volume is up on your phone or computer.
- Can I operate the Apps of any phone through the headset after connecting the wireless headset to the phone?
- Answer: Some apps may not support being operated through the headset due to their settings.
CAUTION
- Reasonable control of t he volume and time of usage.
- Do not use it in hazardous stiction to ensure sr3fet y.
- Do not listen to mL1sic, call up or answer the phone while driving, to avoid danger caused by distraction.
- Keep it out of reach of child re n, to avoid danger caused by improper use,
- Do not use it in damp environment.
- If discomfort or irritation occurs when using t he headset, stop using it immediately.
- Do not store it under the temperature below -1 0″ or above so to avoid shortening the service life of headset and battery.
- The lithium polymer battery of the product is not detachable and replaceable.
- Charge the headset every three months when not in use for a long time, to extend the lifespan of t he battery.
- The battery of product should be disposed of properly or sent to professional recycling center. Do not toss the product into fire.
FCC STATEMENT
This equipment has been tested and found to comply with t he limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed ta provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, the re is no guarantee t hat interference will not occur in a part . If this equipment does cause harmful interference ta radio or television reception, which can be determined by turning the equipment off and o n, the user is encouraged to try to correct the interference by one or more of t he following measures: (1) Reorient o r relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connect ed. (4 )Consult the dealer or an experienced radio/TV technician far help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approve d by t he party responsible far compliance could void the user’s authority to operate the equipment. For further inquiries please visit us at our website, www.knztech.com/support.
WARRANTY
KNZ Technology LLC. warrants this product as free of defects in material, design, and workmanship for the period of one year from the original date of purchase . The warranty is limited to t he original purchaser. If during the period of warranty this product p roves defective under normal use and service, you should ret urn the product to t he retailer from whom it was purchased or to an authorized warranty center. The liability of KNZ Technology LLC. and its appointed repair company is limited to the cost of repair and/or replacement of the product under warranty. Products sent for warranty service must be accompanied by a copy of the original purchase receipt, the original box, materials, and accessories. All cost associated with t he return of t he product under warranty are the responsibility of t he original purchaser.
Shipping and Handing Fee will apply in order for KNZ Technology LLC. ta ship out a new/refurbished product to a customer. KNZ Technology LLC. will not assume any responsibility for any loss or damage occurred in shipping.
KNZ is registered trademark of KNZ Technology LLC. All other trademarks are the property of t heir respective owners. Copyright 2021 . All rights reserved. This product is not a toy. Contains small parts, not for children under 3 years original purchase receipt, the original box, materials, and accessories. All cost associated with t he return of t he product under warranty are the responsibility of t he original purchaser.
Shipping and Handing Fee will apply in order for KNZ Technology LLC. ta ship out a new/refurbished product to a customer. KNZ Technology LLC. will not assume any responsibility for any loss or damage occurred in shipping.
KNZ is registered trademark of KNZ Technology LLC. All other trademarks are the property of their respective owners. Copyright 2021 . All rights reserved. This product is not a toy. Contains small parts, not for children under 3 years.
