Maisto 82561 Radio Control Vehicles User Manual
Maisto – Radio Control Vehicles
Please keep this owner’s lns1ruc11on manual for future referenced. It con1alns urn portan1 information.
We reserve the right to improve revise the product specifications without notice.
Class 1 LED Product Maisto 82561 Radio Control Vehicles
Contents:
- RC Vehicle x 1
- Controller x 1
- USB Cable x 1 (Input: DC 5V 2A Output: DC 6.4V 1A)
- 6.4V Li-ion Rechargeable Battery Pack (For Vehicle Use) x 1
- 1.5V “AAA’ LR03/R03 non-rechargeable Battery {For Controller use) x 2
- Owner’s Instruct ion Manual x 1 Maisto 82561 Radio Control Vehicles
Charging the rechargeable battery pack !or the RC vehicle: (Refer to Diagram 1)
- Locale a USB certi1iod port from any out the devices shows below. Too LED initiator inside the USS cable will tum green.
- Connect the 6.4V Li-ion reach greeble battery pack arid the USB Cable correctors, then the LED eradicator will tum of! to show it ls chagrining
- Once the LED indicator turns green again. the battery Is fully charged. It takes around 2.5 hours to fully collage the artery. However, even the LED does not 1um green, do 101 charge the lla1tery more tolan 3 hours. Maisto 82561 Radio Control Vehicles
Note lf the LED twinkle slowly, then 1he USB Cable is ll01 able to work properly. Try lo connect the USB Gable to another USB port. I1 the prattle persist, Immediately disconnect 1he 1Jat1ery arid tile USB Gable and seek replacement. Maisto 82561 Radio Control Vehicles
Battery installation for the controller: (Refer to Diagram 2)
- Switch the power OFF. Maisto 82561 Radio Control Vehicles
- Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included).
- Install 2 new 1 .5V “AAA” LR03/R03 battery with correct polarity ( +/-) as shown inside the battery compartment.
- Install the battery cover and then tighten the screw on the battery cover.
Battery installation for the vehicle: (Refer to Diagram 3 & 4)
- Switch the power OFF. Maisto 82561 Radio Control Vehicles
- Rotate the battery cover latch aside and open the battery cover.
- Install 6.4V Li-ion rechargeable battery into the battery compartment. Connect the rechargeable battery pack to the socket in the battery compartment.
- Install the battery cover and turn the latch to lock it in position.
How to play: (Refer to Diagram 4, 5, 6 & 7)
- Follow the “Assembly Instructions and video” to set up the vehicle. Maisto 82561 Radio Control Vehicles
- Set the “Power Switch” on the controller and vehicle to ON position , the “Power LED” on the controller will flash less than 3 seconds then stay on, meaning the automatic frequency matching between the controller and the vehicle is completed.
- If the “Power LED” of the controller flash more than 3 seconds, switch off both the vehicle and controller, then turn them on again.
- Pull the trigger in the transmitter to drive the vehicle forward. Push the trigger in the transmitter to drive the vehicle backward.
- Turn the steering knob on the transmitter to steer the vehicle to right or left.
- If the vehicle does not run in a straight line, adjust the wheel alignment under the chassis.
- Turn the switch of tl1e con trolled and vehicle to OFF position when not in play.
Per1ormance Tips:
- Do not drive the vehicle on grass, sand or go through water. Maisto 82561 Radio Control Vehicles
- Do not drive the vehicle in windy or rainy weather.
- Do not drive the vehicle into any hard object.
- Keep fingers, hair and loose clothing away Diagram 7 from the vehicle.
- It’s not allow children to ride on the vehicle. Maisto 82561 Radio Control Vehicles
- The operating range can be affected by a variety of factors:
a) Weak controller or vehicle batteries.
b) Interference from other items that emit radio frequency signals such as another RIC item on the same frequency, CB radios, cordless phones, high voltage transmitter, etc. - Outdoor usage is recommended in order to get optimal control range. Maisto 82561 Radio Control Vehicles
- Remove the package, take out all accessories and assemble the product before giving it to children to play.
Cautions:
- The 6.4V Li-ion battery pack 1nust be charged before use. Use only the battery pack and USB Cable that came with this vehicle.
- Do not overcharge the Battery Pack. Do not charge for more than 3 hours except for the initial two charges. Maisto 82561 Radio Control Vehicles
- Do not charge the Battery Pack if it shows leakage, corrosion, or has loose or exposed wires or other damage.
- Do not cover the Battery Pack with any sort of material while charging.
- Do not touch the Battery Pack when it is hot. Wait until the Battery Pack cools before in stalling it in the Vehicle and before recharging.
- Do not dispose of the Battery in fire. Maisto 82561 Radio Control Vehicles
- Do not dismantle the Battery or USB Cable, and do not cut the Battery or USB Cable.
- The Battery Pack will be warm after charging, and hot after use in a Vehicle.
- The supply terminals are not to be short-circuited.
- Rechargeable Batteries are to be removed from the toy before being charged.
- Rechargeable batteries are only to be charged by adults or by children at least 8 years old.
- Battery change must only be made by adults!
- The USB Cable is not a toy. Maisto 82561 Radio Control Vehicles
- Use only the USB Cable to charge the 6.4V Rechargeable Li-ion battery pack that comes with the product. Other types of battery may burst causing injury to persons and damage. Regularly examine the USB Cable for any damage to the cord, plug, enclosure and other parts. If any damage is found DO NOT use the USB Cable or Battery Pack until it is replaced. Do not use the USB Cable for any use other than instructed in this manual.
- Note that the 1.5V “AAA” Battery is non-rechargeable and is not to be recharged. Only Batteries of the same or equivalent type as recommended are to be used. It will need replacement when transmission is poor. Alkaline AAA batteries are recommended to be used for the transmitter. Do not mix alkaline, standard or rechargeable batteries. Do not mix old and new batteries or different type of batteries. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions.
- Exhausted batteries must be removed from the product. Maisto 82561 Radio Control Vehicles
FCC Label Compliance Statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :
- This device may not cause harmful interference, and Maisto 82561 Radio Control Vehicles
- This device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. 11 this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Maisto 82561 Radio Control Vehicles
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to whicl1 the receiver is connected.
– Consult the dealer or an experienced radio/lV technician for help.
Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Disposal of batteries Maisto 82561 Radio Control Vehicles
Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries.
You can hand in your old batteries at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances: Maisto 82561 Radio Control Vehicles
Pb = Battery contains lead
Cd= Battery contains cadmium
Hg = Battery contains mercury
RSS-210 Compliance Statement:
This device contains licence-exempt transmitter(s)receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference;
- This device must accept any interference, including interference that may cause undesired operation of the device. Maisto 82561 Radio Control Vehicles
Maisto International, Inc.
Fontana, CA 92336, U.S.A.
