ThermoWorks ThermoPop User Manual

ThermoWorks ThermoPop User Manual

  • Rotating display
  • Left- and right-handed use
  • Super-Fast® 3-4 seconds
  • Splash-proof design
  • Big backlit digits
  • Wide range –58 to 572°F
  • Guaranteed accuracy ±2°F to 248°F
  • Switchable °C/°F
  • 9 colors!

Instrument Operation

ThermoWorks ThermoPop User Manual - Instrument Operation

Press the (Power/backlight icon) to activate the thermometer.
The backlight will turn off in 10 seconds to save battery life.
Press again and backlight comes on again for 10 seconds.
The ThermoPop will turn off automatically after 10 minutes to save battery life.

Insert the stainless steel probe to the desired depth.
ThermoPop will measure temp at the tip’s location. Minimum immersion depth is 3/8″. After 3 seconds the display will be within 1° of the final reading. If the display keeps changing the temperature of the subject is still changing.

To Rotate Display

ThermoWorks ThermoPop User Manual - To Rotate Display

Press the ROTATE button located on the back of the thermometer to rotate the display 90˚ until it reaches the desired viewing angle. On power up ThermoPop remembers the last angle used saving you the hassle of setting it every time ThermoWorks ThermoPop .

To Select °F or̊ °C

Press the °C/°F button on the back of ThermoPop to select the desired temperature unit.

Battery Installation

Replace the battery when “lo bat” flashes on the screen. Replace with a 3 volt, type CR2032 button cell battery or equivalent. Use a coin to open the battery cover on the back. Install the battery observing the correct polarity. Close the battery cover ThermoWorks ThermoPop .

Care and Cleaning

Clean the probe immediately after each measurement to avoid cross contamination. Do not expose the entire thermometer to temperatures over 190°F (88°C). Do not leave inside ovens ThermoWorks ThermoPop .
Not submersible.

Technical Support

For warranty, service, and technical assistance, please contact ThermoWorks’ Technical Support at (801) 756-7705 or email at [email protected].

For additional cooking tips and doneness temperatures, and to see the full line of ThermoWorks tools, visit our website at www.thermoworks.com.

Specifications

Range –58 to 572°F (–50 to 300°C)
Accuracy ±2.0°F (±1°C) from –4 to 248°F (–20 to 120°C); ±4.0°F (±2°C) thereafter
Resolution 1° over full range
Response About 3-4 seconds
IP Rating IP66
Operating Range 32 to 122°F (0 to 50°C)
Probe 4.5 L x 0.1 inch dia. reduces to 0.06 inches dia. (114 L x 2.5 mm dia. reduces to 1.5 mm dia.)
Auto-Off After 10 minutes
Auto Backlight 10 seconds
Battery CR2032 (3V) lithium coin cell x 1, 5,000 hours
Display 0.95 dia. inches (24 dia. mm);
Digits: 0.35 H inches (9 H mm)
Product Size 7 H x 1.8 W x 0.8 D inches (178 H x 45.2 W x 20 D mm) ThermoWorks ThermoPop

Chef-Recommended Temps 

ThermoWorks ThermoPop User Manual - Chef-Recommended Temps

* These temperatures are ideal peak temperatures. Meats should be removed from heat several degrees lower and allowed to rise during resting.
** Chef-recommended temperatures are consistent with many expert sources for taste and safety. USDA-recommended temperatures are 5 to 10°F (2 to 5°C) higher ThermoWorks ThermoPop .

Minimum Done Temps for Food Safety 

ThermoWorks ThermoPop User Manual - Minimum Done Temps for Food Safety

Water Temps (at sea level) 

ThermoWorks ThermoPop User Manual - Water Temps

Other Food Temps

ThermoWorks ThermoPop User Manual - Other Food Temps

Candy or Sugar Syrup Temps

ThermoWorks ThermoPop User Manual - Candy or Sugar Syrup Temps

www.thermoworks.com
741 E. Utah Valley Dr.
American Fork, UT 84003

ThermoWorks Logo

For service or warranty:
1-800-393-6434
1-801-756-7705
[email protected]

Leave a comment

Your email address will not be published. Required fields are marked *