VAVA Smart Baby Thermometer User Manual

VAVA Smart Baby Thermometer
User Manual

SAFETY INSTRUCTIONS

• NOT Do not allow children to play with this product.
• Do not place this product under the conditions of fire or high temperature (extremely hot).
• Do not forcefully press, knock or rip this product apart. VAVA Smart Baby Thermometer

CAUTION

• Please read this user manual carefully and operate correctly as instructed in the user manual VAVA Smart Baby Thermometer
• Never try to disassemble this product by Non-professional maintenance or dismounting of the spare parts are not allowed.
• Do not place and use this this product under high temperature or humidity. Do not expose it to the (Operating Temperature: 0~45°C / 32~113°F for charging; -10~60°C / 14~140°F for discharging; Storage Temperature: -20~60°C / -4~140°F)
• To reduce the risk of fire or explosion, do not expose the product to rain or fire.
• Stop using immediately if leakage or deformation Please contact us at [email protected].
• Rinse out with clean water immediately if leakage enters the eyes by Severe cases should be immediately to the hospital for medical treatment.
• Use original or authorized charging device only to avoid abnormalities.
• Do not cut up or impale the power Avoid short circuit.
• Dispose this product as per local law and regulations VAVA Smart Baby Thermometer

PACKAGE CONTENT

• 1 x Temperature Sticker
• 10 x Non-woven tapes
• 1 x Storage Box
• 1 x Type-C Charging Cable
• 1 x User Manual
• 1 x Thank You Card

PRODUCT DIAGRAM

1. Power Button
2. Temperature Sticker
3. Non-Woven Tape
4. LED Display
5. Alarm Ring
6. Storage Box
7. °C / °F Switching Button
8. Type-C Charging Port

LED DISPLAY

 SPECIFICATIONS

Temperature Sticker

Storage Box

 GET STARTED

1. Turning ON the Smart Thermometer
   • Storage Box
     Press and hold the Power Button, the LED display will light up from left to right, correctly showing the ambient temperature and the battery level of both storage box and temperature sticker. VAVA Smart Baby Thermometer
   • Temperature Sticker
     Take the temperature sticker out of the storage box, it will be turned on automatically with LED indicator (on the temperature sticker) flashing 3 times.

2. Pairing
   • The temperature sticker will pair with the storage box automatically
   • Successfully paired: LED Display show the Body Temperature Mode (Body Temperature Mode indicator on).
3. VAVA Smart Baby Thermometer Body Temperature Measurement
   • Paste Non-Woven Tape on Temperature Sticker
     1) Take out one piece of non-woven tape, rip off the release paper 1, then paste it to the back side of the temperature After pressing for 3s, put the temperature sensor through the hole of the non-woven tape.
     2) Rip off the release paper 2, then fix the temperature sensor on the back side of the non- woven
     • Measure the Body Temperature
     • Paste the fixed temperature sensor to the armpit, and lightly press to make sure it is closely attached to the skin.
     • Rip off the release paper 3, then paste the temperature sticker to the The temperature sticker will start measuring the body temperature. VAVA Smart Baby Thermometer

4. Ambient Temperature Detection
   • Place the temperature sticker back into the storage box with the metal patch facing down and plug in the power supply.
   • At this point, the LED display starts to show the ambient temperature.
5. Switching between °C and °F
   • Toggle the switch button on the bottom of the storage box to switch between °C and °F. VAVA Smart Baby Thermometer

ALARM REMINDS

1. Fever Alarm: When the temperature reaches 38°C, fever alarm will be triggered with:
   • Beep sound + alarm ring flashing red + temperature display every 1 second
   • Manually press the Power button to cancel the alarm
   • If the temperature keep rising (more than 5°C), the fever alarm will be re-triggered.
2. Battery Low
   • Temperature Sticker VAVA Smart Baby Thermometer

• When the temperature sticker is in low battery, the charging indicator on the top left corner of the LED display will flash every 1 second with beep
• After putting the temperature back to the storage box for charging, or manually pressing the Power button, the alarm will be
  • Storage Box
• When the storage box is in low battery, the charging indicator on the top right corner of the LED display will flash every 1 second with beep
• After connecting the storage box for charging via Type-C charging cable, or manually pressing the Power button, the alarm will be

3. Disconnection Alarm
   • When the temperature sticker is disconnected with the storage box, the LED display will show “– . – C” every 1 second with beep sound.
4. Fall Off Alarm: When the temperature drops below 35°C, fall off alarm will be triggered with:
   • Beep sound every 1 second until manually pressing the Power button to cancel the alarm.  VAVA Smart Baby Thermometer
   • The LED display will keep flashing “Fall” until the temperature restores to normal or manually pressing the Power button to cancel the alarm.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving
• Increase the separation between the equipment and
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
• Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired VAVA Smart Baby Thermometer

WEEE Compliance

DO not to dispose of product as unsorted municipal waste and to collect such WEEE separately, for proper treatment, recovery and recycling, please take this product(s) to designated collection points where it will be accepted free of charge. Please contact your local authority for further details of your nearest designated collection station. VAVA Smart Baby Thermometer